STANDARD MANDREL TYPE HANGER
THE SERIES 10-2200 STANDARD MANDREL TYPE HANGER IS USED WHEN RUNNING 1-1/4" JOINTED TUBING IN THE HOLE. IT CAN BE ADAPTED TO INCORPORATE A SLIP TYPE CONNECTOR IN THE BOTTOM OF THE HANGER TO ACCOMMODATE COILED TUBING. HOLD DOWN SCREWS ARE PROVIDED TO HOLD THE HANGER DOWN WHEN ANNULUS PRESSURE IS PRESENT. THE HANGER HAS TWO BI-DIRECTIONAL SEALS THAT SEAL IN BOTH DIRECTIONS.
THIS HANGER MAY BE INSTALLED INTO THE EXISTING TREE WITHOUT HAVING TO RE-PLUMB THE FLOW LINES. IT ALSO PROVIDES AN ANNULUS ACCESS FOR GAS INJECTION OR WATER INJECTION FOR JET OR HYDRAULIC PUMPING.
THE SERIES 10-2400 SEGMENTED COIL TUBING HANGERS CONSIST OF A SLIP, CONE, SEAL AND BASE PLATE ASSEMBLY. A WINDOW IS USED TO INSTALL THE SLIPS, WHICH WILL FIT THRU THE I.D. OF A 2.50" BOP, AND RUN AND LAND IN THE
HANGER BODY. HOLD DOWN SCREWS ARE RUN INWARD ON TOP OF THE SLIPS TO PREVENT ANY HYDRAULIC EFFECT ON THE COILED TUBING.
AVAILABLE IN 5000 PSI OR 10000 PSI WORKING PRESSURE FOR STANDARD OR SOUR SERVICE.
SEGMENTED HANGER
